How to install the anti-climbing device correctly?

The anti-climbing device is a very important component in the construction of railway lines. It belongs to railway equipment and plays an important role in the entire railway line. Therefore, no matter when purchasing an anti-climbing device or installing an anti-climbing device, extra attention is required.
It is recommended that when purchasing the anti-climbing device, it is necessary to carefully check to ensure that the quality of the anti-climbing device is qualified, and will not cause frequent failures due to quality problems and affect the service life. In addition, when installing the anti-climbing device, it is also necessary to strictly follow the correct process. If it is installed incorrectly, it may cause hazards when the vehicle is running. So, what is the correct installation method?
Spread the anti-climbers and supports around where they will be installed or replaced. Remove the track bed where the anti-climbing device and supporting wood are installed. If the sleeper where the support is installed is deflected, it needs to be corrected in time. After the load-bearing wooden pad is installed, the anti-climber is hung on the bottom of the rail by the supporting wooden pad, and the pin is installed. Lightly hit the anti-climber and the pin with a hammer until it is tight. This is the installation method of the anti-climbing device, and the whole process is not complicated.
The installation of the anti-climbing device cannot be ignored. If it is not installed properly, many safety hazards will be buried. Therefore, railway equipment manufacturers hope that the majority of users can install the anti-climbing device in strict accordance with the correct process. This is not only to ensure safety, but also to further play the role of the anti-climbing device.